Product Description:

The MAC041C-0-TS-2-E/050-A-0/S001 is a compact AC servo motor produced by Bosch Rexroth Indramat for the MAC AC Servo Motors series. It is intended for closed-loop actuation on light-to-medium automation axes, pick-and-place modules, and indexing stations where position and speed control are required. By combining permanent-magnet excitation with a low-inertia rotor, the unit supports quick acceleration while maintaining the consistent torque needed for repetitive industrial cycles. This layout suits compact machinery that benefits from responsive starts, short settling times, and stable velocity regulation during repeated move sequences.

Mechanical layout follows frame size C, giving a square flange suited to tight machine frames. Power reaches the windings through a connector on side A, allowing cable entry parallel to the mounting surface. Internal sensing uses tacho feedback, so the drive receives a direct velocity signal for simple analog speed loops. Heat is removed by natural convection, eliminating the need for fans. The analog tachometer yields a millivolt-per-rpm output that the controller can scale for proportional deceleration ramps. This passive cooling method depends on unrestricted airflow around the housing fins, so installation clearances must remain open. Cable routing stays straightforward when the motor is mounted close to guards, brackets, or slide mechanisms.

The overall housing length aligns with build index 041, enabling tight coupling to gears or ball-screw assemblies without excessive overhang. Electrical behavior follows the TS winding code, which gives the resistance and back-EMF needed for stable current control from older amplifiers. Because it is a motor for analog drives, command voltages can be applied directly as ±10 V references without an added fieldbus converter. The assembly includes no blocking brake, which reduces rotating mass but means vertical axes must rely on an external holding device during power-off conditions.