Product Description:

The MAC041C-0-LS-2-E/050-B-0/S007 is a servo motor built by Bosch Rexroth Indramat for the MAC AC Servo Motors series. Classified as a motor for analog drives, it converts drive current into controlled rotary motion for positioning axes, pick-and-place heads, and other automation loads that require repeatable speed and torque. As part of a closed-loop drive system, the unit pairs with legacy analog amplifiers and delivers torque proportional to commanded current, allowing reliable integration into machinery that predates fully digital interfaces. That operating method suits equipment that still relies on established analog velocity and torque control rather than network-based motion hardware.

Its cooling relies on passive surface dissipation through natural convection, which removes heat without fans and supports installation where airflow is limited. Rotor position and speed are reported by an internal generator configured for tacho feedback; this analog signal lets the drive calculate velocity in real time and stabilize the control loop. The size code 041 identifies the motor frame for compact installations, while the length code C indicates the housing length within that frame size. The LS winding code matches the stator's electrical characteristics to compatible analog drives, helping the motor respond properly to the intended current and voltage range.

The motor has no blocking brake, so it does not provide holding torque when power is removed and vertical axes require an external holding method. Power enters through a connector on side B, which helps keep cabling away from the shaft end and leaves the drive end clear for couplings or other transmission components. The unit is part of the MAC AC Servo Motors platform and uses the connector and mounting pattern commonly associated with that product line. This layout helps the motor fit into compact machine assemblies where predictable cable routing and consistent mechanical alignment are important.