KDA 3.1-150-3-L0S-U1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat KDA 3.1-150-3-L0S-U1 is a spindle drive from the KDA Spindle Drives series with a rated current of 150 Amps and a DC supply voltage of 300 Volts. This drive uses forced cooling with a mounted heatsink blower that operates at 115V and 50-60Hz. It features a SERCOS interface for speed command and a serial interface (RS 232 C), and supports installation at elevations up to 1000 meters above sea level.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The KDA 3.1-150-3-L0S-U1 spindle drive is manufactured by Bosch Rexroth Indramat for the KDA Spindle Drives series. It serves as the power and control stage between a machine DC link and a motor spindle, converting bus energy into regulated three-phase output for CNC operation. Inside a rack, the module interprets speed commands and supervises feedback so the spindle can accelerate, hold commanded speed, and brake in step with the programmed machining cycle. That arrangement supports stable speed regulation during cutting, drilling, and other spindle-driven processes that depend on repeatable velocity.
The internal power section draws 300 VDC from the common bus and can supply a continuous 150 A to the spindle windings. Cooling support power for the electronics is provided at 115 V/50–60 Hz, which runs the fan system attached to the heat sink. Motion commands are transmitted through the SERCOS interface, giving the CNC a deterministic fiber-optic communication path for speed control and synchronization. A service connection based on a Serial interface (RS-232 C) supports parameter transfer and diagnostic access, so local setup data and status information can be read without using the motion network. This separation allows the drive to handle real-time spindle control while keeping a dedicated channel available for local communication.
The drive is intended to operate in ambient temperatures from 5 to 45 °C and at installation heights up to 1000 m above sea level. Heat is removed by forced cooling using a mounted heat sink blower, and the control board monitors that airflow source during operation. Because the design does not include a second encoder input, the spindle encoder channel must be shared with the CNC feedback loop. This layout fits applications where the spindle feedback is already routed through the primary control channel and no separate auxiliary encoder input is needed at the drive.
Frequently Asked Questions about KDA 3.1-150-3-L0S-U1:
Q: What is the rated current of the KDA 3.1-150-3-L0S-U1 spindle drive?
A: The KDA 3.1-150-3-L0S-U1 spindle drive operates with a rated current of 150 A, supporting high-demand spindle motors.
Q: How is the KDA 3.1-150-3-L0S-U1 spindle drive cooled?
A: This model uses a mounted heatsink blower with forced cooling to maintain optimal operating temperature.
Q: What AC power is required for the heatsink blower on this spindle drive?
A: The KDA 3.1-150-3-L0S-U1 accepts an AC power source for the heatsink blower rated at 115V and 50-60Hz.
Q: What type of additional interface is included on the KDA 3.1-150-3-L0S-U1?
A: A serial interface (RS 232 C) is available on this model for communication and control.
Q: What is the maximum installation elevation for the KDA 3.1-150-3-L0S-U1?
A: The maximum installation elevation for this spindle drive is 1000 meters above sea level.
