KDA 3.1-150-3-DYD-W1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat KDA 3.1-150-3-DYD-W1 is a spindle drive from the KDA Spindle Drives series and has a rated current of 150 Amps. It features forced cooling with a mounted heatsink blower operating at 220V and supports digital position and speed command values. The drive is suitable for ambient temperatures from 5 to 45 degrees Celsius and can be installed up to 1000 meters above sea level.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The KDA 3.1-150-3-DYD-W1 is a drive module produced by Bosch Rexroth Indramat for the KDA Spindle Drives series. Version 3 of the series is intended to regulate high-speed machine-tool spindles by converting a fixed DC bus into variable three-phase outputs that follow digital speed references. By linking the motor, encoder, and numerical control, the unit provides precise velocity and position control required for automated machining centers, grinding heads, and similar equipment on the factory floor. Its control functions support stable spindle response during rapid acceleration, deceleration, and orientation tasks. This makes the module suitable for applications where spindle speed must track control commands closely during cutting cycles.
The drive draws its main power from a bus at 300 VDC and can deliver up to 150 A of continuous output current to the spindle motor. A separate blower circuit rated for 220 V at 50/60 Hz powers the heat sink fan, and the thermal design relies on forced cooling through a mounted blower. Internally, velocity setpoints are accepted as a 16-bit parallel digital speed command, allowing direct connection to numerical controls without analog conversion. The drive also offers a digital position command interface for tighter contouring tasks, and its DC-link architecture requires an external supply module to maintain the 300 V line during regenerative operation. This arrangement lets the module respond quickly to commanded speed changes while remaining compatible with digital machine controls.
Ambient operating limits span 5 to 45 °C, and full performance is maintained up to 1000 m above sea level without derating. Cooling air is moved by a mounted heat sink blower, and the power stage is isolated from the control electronics to minimize vibration transmission. In addition to the primary encoder channel, a second encoder input and synchronous input allow the controller to reconcile spindle feedback with machine axes and orient the shaft for tool changes. Separate feedback paths also help the control system keep spindle motion aligned with synchronized machine events. The additional feedback capability is useful when spindle orientation must match the timing of auxiliary machine motions.
Frequently Asked Questions about KDA 3.1-150-3-DYD-W1:
Q: What cooling method is used in the KDA 3.1-150-3-DYD-W1 spindle drive?
A: The KDA 3.1-150-3-DYD-W1 spindle drive uses a forced cooling system with a mounted heatsink blower.
Q: What is the rated current capacity of the KDA 3.1-150-3-DYD-W1 spindle drive?
A: This drive supports a maximum rated current of 150 A.
Q: What is the required AC source for the heatsink blower of the KDA 3.1-150-3-DYD-W1?
A: A 220V AC source at 50-60Hz is required for the heatsink blower on this model.
Q: What is the maximum installation elevation for the KDA 3.1-150-3-DYD-W1 spindle drive?
A: The drive can be installed up to 1000 meters above sea level.
Q: What type of position command value interface is available on the KDA 3.1-150-3-DYD-W1?
A: The KDA 3.1-150-3-DYD-W1 provides a digital position command value interface for precise control requirements.
