The HDS05.2 series drive controllers are among the digital DIAX04 drive controllers created and developed under the Indramat firm which was later taken over by Bosch Rexroth Company. These modular designed drive controllers have 300 amp capacity which is sufficient for driving most of the Indramat’s largest motors. The HDS05.2 drive controllers are integral to most of the applications requiring higher energy such as line shafted printing, cutting of large as well as heavy items, and rolling heavy materials among others. These drives are composed of software modules, base units, modules for command communications, configuration type plates, and provision for at most three extra plug-in modules. Inappropriate use of the HDS05.2 drive controllers can be hazardous. Therefore, the user of these drive controllers must observe all the safety warnings stipulated by the producer.
When these drive controllers are operated or used outside the conditions designated by the producer, they will be damaged. These drive controllers can function properly only when conditions such as the appropriate installation elevation and ambient temperature are observed. The HDS05.2 drive controllers satisfy IP 10 protection category according to EN 60 529. The design of these drive controllers allows them to be mounted into a closed housing or even a control cabinet according to section 6.1.3 of EN 50175/1988.
The HDS05.2-W300N-HA38-01-FW drive controller created by the highly competitive firm of Indramat is in the DIAX04 controller family. The function ID code of this drive controller is 38. This drive controller also features an analog interface as well as a built-in blower. Additionally, the HDS05.2-W300N-HA38-01-FW drive controller is fitted with 2 ground connections which are also known as the grounding system. This drive controller’s grounding system is connected to the mounting rails as well as the unit’s back wall and grounding clips found at the unit’s front side.
|Version of Function ID||1|
|Cooling Type||Air, internal (with built-in blower)|
|Rated Current||300 A|
|Command Communication||ANALOG Interface|
|Function ID Code||38|
Wake Industrial sells new surplus and reconditioned products. This website is not sanctioned or approved by any manufacturer or tradename listed. Wake Industrial is not an authorized distributor or representative for the listed manufacturers. Designated trademarks, brand names and brands appearing herein are the property of their respective owners.
Copyright 2019 - Wake Industrial - All Rights Reserved