Product Description:

The HDS04.1-W200N-HA24-01-FW is a drive controller produced by Bosch Rexroth Indramat for the HDS Drive Controllers series. Within an automation cell, the unit serves as the power and regulation stage between a higher-level motion processor and the connected servo motors. It converts command signals into controlled current and voltage so axes can follow speed and position commands with stable response. This type of controller is used where the control section and power section are separated, allowing the motion processor to issue commands while the drive handles motor current regulation. That arrangement supports repeatable acceleration, deceleration, and holding behavior during automated cycles.

This controller communicates with the host motion system through an analog interface, so reference values are delivered as continuously variable voltages rather than by fieldbus words. Its rated output is 200 A, which is the maximum continuous motor current the power section can supply without derating. Thermal energy is removed by a built-in air blower, which circulates cabinet air across the heat sink and removes the need for external ducting. The unit belongs to the DIAX04 platform, so it fits the same modular arrangement used by related power supply and drive components. This format suits systems that use analog command sources instead of networked drive control.

The unit is Version 1. As an HDS Drive Controller, it follows the programming and diagnostic structure used across this platform. The product is assigned to Line 04, which identifies its design line within the series. That line code is used to distinguish the matching mechanical layout and connector arrangement for the unit. Consistent diagnostics across multiple axes help keep status reporting and parameter access aligned in shared racks.