Product Description:

The HDS04.1-W200N-HA14-01-FW is an industrial drive controller produced by Bosch Rexroth Indramat and supplied within the HDS Drive Controllers series. As a programmable axis module, the unit supplies and regulates power for servo drives in multi-axis machinery. Within an automation rack, it serves as the power stage that converts DC bus energy into controlled three-phase output, allowing fabrication cells, packaging lines, and handling robots to follow repeatable velocity and position profiles. Higher-level PLCs or motion controls send command values to the drive, and the controller adjusts motor output so the connected axis responds smoothly during acceleration, deceleration, and positioning moves.

The controller exchanges setpoints and feedback through an analog command interface, which allows continuous voltage reference signaling from legacy motion cards without requiring digital fieldbus conversion. This arrangement is useful in systems that still rely on analog command paths for speed or position control. It belongs to the DIAX04 platform, so the module uses the shared connector layout and diagnostic structure common to that system. Nominal output capacity is rated at 200 A, allowing the module to operate large torque motors within its current range. Temperature control is assisted by a built-in internal air blower, which moves cabinet air across the heat sink without external ductwork. The unit is part of Line 04.

The drive is version 1. Because command transmission uses an analog voltage pair, signal wiring should be kept short and routed carefully to reduce noise pickup. The internal blower keeps air moving across the heat sink even when the cabinet remains closed, which helps maintain stable thermal conditions during long production runs. Its modular format also lets it sit alongside companion supply and control units in the same drive cabinet, keeping the power section concentrated in one location.