Product Description:

The HDS03.2-W100N-HS62-01-FW is a drive controller produced by Bosch Rexroth Indramat and placed within the HDS Drive Controllers series. In an automation rack, it acts as the power and control stage for servo axes by converting DC-bus energy into regulated motor current. That allows connected motors to respond to torque, speed, and position commands issued by a CNC or PLC. The unit also monitors operating status and can shut down an axis when a fault condition is detected. By combining current control and communication functions in one module, it reduces the number of separate components required in the drive cabinet.

Communication is handled over the fiber-optic SERCOS ring, which provides deterministic data exchange between the control system and each axis. Inside the DIAX04 platform, the controller shares bus rails and supply infrastructure with compatible modules of the same generation. Thermal management is handled by a built-in air blower that moves cabinet air across the heat sinks without an external duct. The power section is rated for a continuous output of 100 A, allowing the unit to drive axes that require sustained torque during positioning and acceleration. This arrangement supports coordinated motion in multi-axis machinery where synchronized response is important. Typical applications include packaging equipment, handling systems, and transfer lines that rely on synchronized servo motion.

The product is part of Line 03 in the series, and the unit is Version 2. The HS62 command module code identifies the interface configuration installed in this controller. These identifiers distinguish this model from similar units in the same platform. The model code groups the controller section, current class, command module, and revision markers into one designation, which helps keep rack identification consistent during installation and service.