HDS03.2-W075N-HA19-01-FW Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
5 Minutes
37 Seconds
The Bosch Rexroth Indramat HDS03.2-W075N-HA19-01-FW is part of the HDS Drive Controllers series, designed for use in the DIAX04 controller family. This drive controller has a rated current of 75 A and uses a built-in internal air blower for cooling. It features an analog command communication interface.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The HDS03.2-W075N-HA19-01-FW is a drive controller in the HDS Drive Controllers series. It is installed in DIAX04 multi-axis systems to regulate servo power modules and coordinate motor motion in automated machinery. The controller is intended for applications that require accurate current regulation, dependable feedback handling, and stable axis response during continuous duty. In these systems, it forms the regulation stage between the power section and the motor feedback loop. The unit is suited to machines where several axes must respond predictably to command changes and load variation. This helps keep positioning loops steady while machines run through repeated acceleration, deceleration, and holding sequences.
This unit exchanges setpoints and actual values through an ANALOG command interface, allowing straightforward integration with drives or motion cards that use voltage or current references. The same interface can carry demand signals and returned operating values used by the control system. Analog signaling lets higher-level controls send demand values without requiring a digital command bus. Thermal management is handled by a built-in air blower, and the blower moves cabinet air across the heat-sink channels so external ducting is unnecessary. Because cooling air is drawn from the cabinet, airflow around the heat sink must remain unobstructed. Drive output is sized for up to 75 A of continuous motor phase current, giving the axis enough current capacity for sustained load and quick speed changes.
The unit uses hardware Line 03, which identifies the power electronics layout and connector arrangement used on this model. It is supplied in Version 2, marking the revision level for this controller within the HDS range. These identifiers distinguish the controller from earlier releases and help match it with the correct documentation and parameter set. Diagnostic LED patterns and fault-code behavior remain consistent with other axes in the product line. That consistency allows the controller to be integrated into established DIAX04 installations without changing the basic operating method.
Frequently Asked Questions about HDS03.2-W075N-HA19-01-FW:
Q: What command communication interface does the HDS03.2-W075N-HA19-01-FW support?
A: The HDS03.2-W075N-HA19-01-FW uses an analog command communication interface for control and interaction.
Q: What is the rated current specification for the HDS03.2-W075N-HA19-01-FW?
A: This drive controller provides a rated current of 75 A for its connected devices.
Q: How is the HDS03.2-W075N-HA19-01-FW cooled during operation?
A: The HDS03.2-W075N-HA19-01-FW features a built-in internal air blower for cooling.
Q: Which controller family is the HDS03.2-W075N-HA19-01-FW part of?
A: This controller belongs to the DIAX04 controller family, designed to integrate with compatible automation systems.
Q: What version is the HDS03.2-W075N-HA19-01-FW model in its series?
A: The version of this particular model is 2, indicating its specific build and functionalities within the HDS series.
