HDC01.1-A040N-PL02-01-FW Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911291255
Ask for AvailabilityThe Bosch Rexroth Indramat HDC01.1-A040N-PL02-01-FW is part of the HDC DuraDrive Controllers series and uses natural convection for cooling. It features a rated current of 40 Amps with an IP20 protection class and supports a maximum output frequency of 400 Hertz. This controller includes an RS232/485 serial interface and operates with a maximum installation altitude of 2000 meters.
Internal Product Review
The HDC01.1-A040N-PL02-01-FW is a Bosch Rexroth Indramat HDC DuraDrive controller with a 40 A rated current and 400 Hz maximum output frequency. Natural convection cooling and IP20 protection support dependable cabinet integration in controlled industrial environments. A strong choice for drive applications requiring stable and efficient controller performance.
Have a part to sell?
Wake Industrial Warranty
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The HDC01.1-A040N-PL02-01-FW is a drive controller from the HDC DuraDrive Controllers series produced by Bosch Rexroth Indramat. It converts control commands into regulated voltage, current, and frequency for industrial servo axes used in packaging, material handling, and process lines. By integrating power electronics and signal conditioning into one chassis, the unit provides compact motor control for applications that require accurate speed regulation and coordinated motion. This arrangement keeps the control section close to the power stage and supports coordinated axis response in enclosed automation cabinets. It connects directly to upstream PLC networks and is intended for installation inside standard electrical panels.
The controller delivers a continuous output of 40 A, while its heat sinks rely on natural convection for cooling. With a maximum modulation rate of 400 Hz, the inverter can support rapid acceleration profiles without losing control resolution. The housing has an IP20 protection class, so the unit is suited for use inside closed cabinets. A DC-link capacitor of 0.585 mF helps filter line ripple, and communication for setup uses an RS232/485 serial port. Because a dynamic brake is not included, regenerated energy must be routed to external equipment. Full rated performance is maintained up to 1000 m above sea level, which covers most indoor industrial locations.
Above that elevation, output is progressively reduced until the maximum installation height of 2000 m. A 60 Ω soft-start resistor limits inrush during bus energization, and the control circuit can momentarily draw 6.0 A while charging. Protection circuitry withstands 40 V surges for 1 ms, and the power stage can absorb 5 kWs of regenerative energy before external shunting is required. The unit tolerates ambient moisture up to 95 % relative humidity and an absolute moisture content of 25 g/m³, provided condensation is not present. This allows the controller to operate in humid production areas where airborne moisture is managed.
