Product Description

The Bosch Rexroth HCS01.1E-W0005-A-03-B-ET-EC-NN-L3-NN-AW is a drive controller. It has four main components: a power section, a control section, a control panel and the controller firmware. The control panel supplied with the HCS01.1E-W0005-A-03-B-ET-EC-NN-L3-NN-AW is an advanced control panel, which is suited for hot plug and includes a slot for a SD card. The control panel can be used as a programming module. The single-line display on the control panel displays operating states, command and error diagnoses and pending warnings. Using the four-button keypad, operators can display diagnoses and trigger simple commands. The control voltage input for the power section on the HCS01.1E-W0005-A-03-B-ET-EC-NN-L3-NN-AW is 24 Volts DC. The maximum inrush current at 24 Volts DC is 3.3 Amps. The current pulse width is 2 milliseconds. The input capacitance is 0.04 millifarads and the power consumption is 27 Watts.

The HCS01.1E-W0005-A-03-B-ET-EC-NN-L3-NN-AW accepts three-phase input at 200 to 500 Volts AC. The supported mains frequency range is 50 to 60 Hertz. The maximum allowed mains frequency rate of change is 2 Hertz per second. The required wire size for the AC input is 14 AWG. Rated output of the HCS01.1E-W0005-A-03-B-ET-EC-NN-L3-NN-AW is 5 Amps. The communication interface supported by the controller is Multi-Ethernet. The controller is also equipped with a multi-encoder interface and a safety module that supports safe torque off. The HCS01.1E-W0005-A-03-B-ET-EC-NN-L3-NN-AW controller dissipates heated air inside the cabinet. It requires 0 to 40 degrees Celsius ambient temperature. The protection category of the controller is IP20.  The back-side mounting (back of device directly mounted to mounting surface in control cabinet) is the standard and should be used, if possible. Controller installation by trained personnel helps to limit installation errors.