Product Description

The HCS01.1E-W0003-A-02-B-ET-EC-NN-S4-NN-FW drive controller is prone to damage due to non-compliance with the safety instructions. This Bosch Rexroth controller installation is done in accordance with the EMC requirements. The product comprises several connectors that must not be plugged in or removed when it is powered ON. The device may move dangerously at any point of time during operation if the associated motor has operator, software or firmware errors. The unit is meant to be in safe standstill mode before entering or accessing the danger zone. It must be kept disconnected from the power supply when it is being cleaned or during maintenance and repair work.

The drive controller portrays a hot housing surface during or soon after operation. This surface can cause burns if touched. The product takes at least 15 minutes to cool down after the power supply has been disconnected. The device poses a risk of injury if it is either disconnected or opened in a pressurized state. The unit houses an engineering port. It can operate at an ideal temperature ranging from 0°C to 40°C. The controller features a 3K3 climatic category during operation as per IEC 721 specifications. This product cannot be mounted horizontally. This controller comes with a warranty for one year.

The device features 2 pollution degrees. The unit has +/-10% tolerance rated input voltage. It has an air inlet at the bottom and an air outlet at the top. The controller portrays a 12.7W maximum power rating. The product uses a star layout for connecting its 24V supply voltage. This device features a pulse-shaped leakage current. The unit encompasses a ready relay contact with mains voltage. It is essential to use a mains filter featuring a higher nominal current if the operating temperature exceeds 45°C. The clock frequency of the controller is directly based on the interference emissions and leakage currents. It is possible to ship this drive controller to any country in the world.