HCS01.1E-W0054-A-03-B-ET-EC-NN-NN-NN-FW Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911331185
The Bosch Rexroth Indramat HCS01.1E-W0054-A-03-B-ET-EC-NN-NN-NN-FW is a drive controller from the HCS IndraDrive Controllers series with a device peak current of 54 Amps and an IP20 rating. It features MultiEthernet communication and an integrated blower for air cooling, along with an encoder interface supporting IndraDyn Hiperface and EnDat 2.1/2.2. The controller operates on a mains voltage of 3 x AC 200 to 500 Volts plus or minus 10 percent.
Internal Product Review
The HCS01.1E-W0054-A-03-B-ET-EC-NN-NN-NN-FW is an HCS drive controller with MultiEthernet communication that supports efficient network integration. Internal air cooling and IP20 protection make the design well suited for enclosed industrial cabinets. A 54 A peak current with 3 x AC 200 to 500 V mains input highlights strong drive capability for demanding motion applications.
Have a part to sell?
Wake Industrial Warranty
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
Bosch Rexroth Indramat produces the HCS01.1E-W0054-A-03-B-ET-EC-NN-NN-NN-FW within the HCS IndraDrive Controllers series. The device functions as a drive controller that conditions three-phase power, manages feedback, and exchanges fieldbus data. It allows servomotors or induction motors to follow commands from higher-level automation systems in assembly cells, conveyors, or packaging lines where coordinated axis control is required. It is intended for cabinet-based motion systems that combine power conversion and feedback handling in one module.
The controller communicates with plant networks through a MultiEthernet port, which allows protocol selection in software rather than through hardware changes. Its control section is delivered in the BASIC configuration, which provides standard motion functions without additional technology options. At maximum load, the power electronics can supply up to 54 A of peak current to the connected motor windings during rapid acceleration. Heat from the switching devices is removed by internal air cooling, with an integrated blower circulating cabinet air across the heat sink. For mains connection, the unit accepts 3 × AC 200…500 V ±10 %, allowing use across a wide range of industrial supply systems.
Motor position data enters the control loop through the dedicated IndraDyn Hiperface/EnDat 2.1/2.2 encoder interface, supporting high-resolution absolute feedback. The housing meets IP20, so the controller is intended for installation inside a protected enclosure and provides finger-safe access only. The unit is Design Version 1, which identifies it as the first production release for the HCS01 frame. It uses an infeeding and regenerative power section, so it can receive DC-bus power from an upstream supply module and return regenerated energy during deceleration. Interface 2 and the safety interface are not equipped on this version.
