Product Description:

The HCS01.1E-W0009-A-02 is a drive controller from Bosch Rexroth Indramat in the HCS IndraDrive Controllers series. It interfaces between a three-phase mains supply and servo or induction motors, converting incoming energy into controlled voltage and frequency while processing feedback from the connected axis for closed-loop control. Its role in industrial automation is to coordinate motion profiles, monitor load conditions, and apply protective limits during starts, stops, and speed changes. This makes it suitable for packaging machines, handling modules, and small transfer lines that need repeatable speed and positioning performance across routine operating cycles.

It accepts a nominal supply of 3 x AC 110...230 V ±10%, allowing use on low-voltage factory grids without an external transformer. An infeeding and fed power supply stage supports energy sharing among multiple axes when the system is arranged on a common DC bus. During transient acceleration, the control stage can deliver a device peak current of 9 A, which supports short bursts of torque before the drive returns to its normal operating level. Thermal management uses internal air cooling with an integrated blower, so cabinet air moves across the heat sink without extra ductwork. The housing has an IP20 rating, which provides finger protection but does not seal against dust or liquids.

The drive is released as Design 1, so its dimensions and connector layout match the first version of this platform. Within the electrical hierarchy, it is listed under the HCS01 line, which groups units with the same compact form factor and current range. As an HCS Drive Controller, it can be paired directly with IndraDyn motors for closed-loop axis control. The compact platform is suited to control cabinets where space is limited but accurate motor control is still required.