Product Description:

The HCS01.1E-W0008-A-03-B-ET-EC-NN-S5-NN-FW is a drive controller produced by Bosch Rexroth Indramat within the HCS IndraDrive Controllers series. It coordinates power conversion and axis regulation for synchronous and asynchronous motors used in industrial automation cells, conveyors, and assembly lines. Positioned between the mains supply and the motor feedback loop, the unit executes torque, speed, and position commands issued by higher-level PLCs. This arrangement lets a connected axis respond to commanded motion while maintaining stable control during starting, running, and stopping.

The power stage is designed for a three-phase supply of 3 x AC 200 to 500 V ±10%, allowing facilities with either 230 V or 460 V networks to use the same hardware. Under dynamic loading, it can source up to 8 A of peak current, covering low-power servo axes and auxiliary actuators. Internal thermal management is handled by internal air cooling with an integrated blower, so only cabinet airflow needs to be considered during panel layout. The housing carries an IP20 rating, meaning live parts require mounting inside a protected enclosure but no additional gasketing. For controller networking, the device presents a MultiEthernet interface, bringing Ethernet/IP, EtherCAT, and PROFINET access onto a single port without separate option cards. Interface 2 is not equipped on this model, which helps keep the housing width to 50 mm.

This version belongs to the HCS01 line and is design version 1. The control section supplied with the power module is the BASIC variant, and the pairing note indicates that the control and power sections are matched for use together. Position feedback from the motor is accepted through an IndraDyn Hiperface/EnDat 2.1/2.2 encoder connection on the front panel, giving the controller access to rotor position data. The power supply topology is infeeding/fed operation, allowing the device to operate as an energy source or share a common DC bus.