Product Description:

The HCS01.1E-W0008-A-03-A-ET-EC-EC-S4-NN-FW is a drive controller from the HCS IndraDrive Controllers series manufactured by Bosch Rexroth Indramat. Classified under the HCS01 line, the unit regulates power between the plant mains and connected synchronous or asynchronous motors in automated machinery. Within an automation cell, it coordinates torque, speed, and position loops, allowing precise motion sequences while sharing diagnostic data over factory networks. This makes it suitable for motion tasks such as transport axes, feeders, and positioning modules that require consistent response during changing loads.

The controller exchanges control and status frames through a MultiEthernet interface, so it can be integrated into EtherNet/IP, PROFINET, or EtherCAT topologies without hardware changes. Thermal management relies on internal air cooling through an integrated blower, which moves cabinet air across the heat sink and helps prevent derating. The device can supply a peak output current of 8 A, enabling short-term acceleration of low-to-medium inertia axes. It is intended for three-phase mains in the range of 3 x AC 200–500 V ±10%, which covers common 230 V and 400 V plant grids. An enclosure rating of IP20 indicates that live parts must be mounted in a protected electrical cabinet because the housing is not sealed against dust or dripping water.

The unit is in Design 1, which places it in the first mechanical and electrical release of the series. Both encoder ports support IndraDyn Hiperface/EnDat 2.1/2.2 feedback, allowing dual-loop operation with high-resolution motor sensors and accurate feedback processing. The integrated power supply uses an infeeding and feeding configuration, so surplus generator energy can be shared with other drives on the DC bus. When ordered, the power section can be paired with a control section designated BASIC for standard motion tasks.