Product Description:

The HCS01.1E-W0003-A-02-B-ET-EC-CN-S4-NN-FW is produced by Bosch Rexroth Indramat and belongs to the HCS IndraDrive Controllers series. As a compact drive controller, it governs motor speed and torque in automated machinery. It provides closed-loop axis control within production lines and material-handling cells. The unit receives motion commands from the higher-level control system and regulates motor response so the axis follows the requested operating profile. That control behavior is useful on machines that need repeatable starts, stops, and speed changes during routine production cycles.

This controller draws power from a three-phase supply rated at 3 x AC 110–230 V ±10%, and its power stage can deliver a peak current of 3 A to the connected motor. Cooling is handled by internal air cooling through an integrated blower, and the housing carries an IP20 rating, so the unit requires placement inside a protected enclosure. System networking is achieved over the MultiEthernet communication backplane, enabling direct linkage to EtherNet/IP, PROFINET, or other Ethernet-based factory networks without additional hardware. This communication path allows the controller to exchange motion-related commands and status data with the surrounding automation system while remaining suitable for compact cabinet installation.

The control section mounted to this power module is classified as BASIC, matching the B identifier in the product code. Feedback from motors equipped with single-turn or multi-turn sensors is accepted through the Encoder IndraDyn Hiperface/EnDat 2.1/2.2 interface, while higher-level motion sequences or I/O groups can be exchanged via CANopen. The controller uses the Infeeding / Feeded power supply topology, which lets it operate in common DC-bus arrangements where regenerative energy can be shared among axes. This setup supports coordinated servo operation in systems that require feedback processing, network communication, and compact power integration within the same drive platform. It can also fit installations where several axes communicate over a common network while using a shared power structure inside the cabinet.