Product Description:

The HCS01.1E-W0003-A-02-A-CC-EC-ET-S4-NN-FW is a compact drive controller produced by Bosch Rexroth Indramat and assigned to the HCS IndraDrive Controllers series. It governs synchronous or induction axes when used with a matching power supply and motor feedback loop in an automation cell. The unit belongs to the HCS01 line and acts as the power section that carries out torque, speed, and position commands from the paired control section. Its compact format supports installation in control cabinets where coordinated axis control and dependable closed-loop response are required.

Incoming energy is accepted from a three-phase supply of 3 x AC 110 to 230 V ±10%, allowing the device to operate on low- to medium-voltage plant services. Peak output reaches 3 A, which is the maximum current available to the connected motor during dynamic transients. Heat generated by the IGBTs is removed by internal air cooling with an integrated blower, so no external ducting is required inside the panel. Protection against accidental contact follows the IP20 rating, which limits use to enclosed cabinets. Command data move across a deterministic SERCOS III master cross communication bus, enabling multi-axis synchronization over real-time Ethernet.

The controller is fitted with a MultiEthernet port for plant networks that rely on PROFINET, EtherNet/IP, or EtherCAT protocols, and it reads rotor position through IndraDyn Hiperface/EnDat 2.1/2.2 encoder feedback. Application parameters are handled by the ADVANCED control section, which plugs directly onto the power module and is identified as Design Version 1. The power unit supports infeeding and fed operation, so excess energy can return to a shared DC bus or be drawn from it during acceleration. This allows regenerated energy from one axis to be used elsewhere on the common bus instead of being wasted as heat.