Product Description:

The HCS01.1E-W0009-A-02-B-ET-EC-EP-S4-NN-FW is a compact single-axis drive controller produced by Bosch Rexroth Indramat within the HCS IndraDrive Controllers series. It converts incoming three-phase power into regulated motor current and processes encoder feedback, enabling speed, torque, and position control for servo and induction motors used in automated handling cells, packaging machines, and material-processing lines. Its compact format makes it suitable for machine sections where panel space is limited but precise axis control is still required.

For command and diagnostic traffic, the controller offers a MultiEthernet port that combines PROFINET, EtherNet/IP, and EtherCAT on one connector, simplifying network architecture. Motor position data enters through an IndraDyn Hiperface/EnDat 2.1/2.2 encoder interface, so the device supports both incremental and absolute feedback without hardware changes. The inverter stage can deliver a peak current of 9 A, which provides short-term overload capacity during acceleration or rapid stops. It is powered from 3 × AC 110–230 V ±10%, allowing operation on common low-voltage mains. Internal heat is removed by internal air cooling through an integrated blower, which helps keep the temperature rise predictable inside the cabinet.

The unit is Version 1 and uses the BASIC control section identified in the type code, so it is intended for the corresponding feature level. The power section uses infeeding and regenerative DC-bus operation, which allows motoring and regenerative braking on a shared DC bus. The enclosure is rated IP20, which protects against finger contact and settled dust and requires installation inside a control cabinet. This arrangement suits compact machine builds where the drive is mounted with other protected electrical components. The control and power arrangement is suited to organized cabinet layouts where supply, feedback, and network connections must remain accessible.