Product Description:

The FECP01.2-19K0-3P400-A-BN-MODB-01V01 frequency converter is produced by Bosch Rexroth Indramat within the FEC Frequency Converters series. It is installed in automated pump and fan systems to match motor speed with flow demand, reducing energy consumption and mechanical stress. This unit belongs to the first generation hardware platform and is identified as Design 2, which establishes its control cabinet form factor. Its high durability rating supports continuous duty in process environments.

It operates from an AC supply of 3 AC 380 to 480 V, a range that covers typical 400 V industrial grids and allows tolerance for line fluctuations. The converter expects a 3-phase feed, which helps maintain balanced current draw and smoother motor torque production. For transient mechanical peaks, the drive can deliver 120% for 60 seconds of its rated output, while continuous moderate overloads up to 105% for 60 minutes are permitted before derating. The open-frame construction has an IP20 protection class, so it is intended for installation inside enclosed panels where accidental contact is limited and direct water exposure is avoided.

System communication is provided through Modbus, allowing higher-level controllers to adjust frequency setpoints, read status words, and coordinate multiple drives on one network. Local manual speed trimming is not available because the unit is supplied without a potentiometer, which leaves the front panel available for diagnostic LEDs and terminal access. The control electronics use a large panel format, which helps spread heat across a larger surface and simplifies wiring in spacious cabinets. Internally, the power section is designed for the 400 VAC class, matching standard European motor insulation ratings and supporting long cable runs without additional output filters.