Product Description:

The FECG01.2-1K50-1P200-A-SP-NNNN-01V01 is a frequency converter produced by Bosch Rexroth Indramat for the FEC Frequency Converters series. Intended for general automation tasks, this device varies motor frequency so conveyors, pumps, or fans run at commanded speeds without mechanical gear changes. The model belongs to the 1st generation hardware platform and carries the design 2 revision, giving it firmware and component alignment common to early FEC drives. With a mechanical size 1 frame, it fits easily into small panels where cabinet space is limited.

The drive supplies a rated power of 1.5 kW, which identifies the continuous mechanical output the connected motor can receive under nominal conditions. Its housing width of 125 mm determines the lateral clearance required on DIN rail or back-panel mounts. An IP20 protection class allows installation inside enclosed cabinets while permitting finger-safe access to terminals. For short bursts the converter tolerates 200% for 1 second of overload, enabling rapid acceleration of high inertial loads, and it can sustain 150% for 60 seconds to handle moderate surges during normal duty. These overload limits shape the drive selection process when cycle-times fluctuate or starting torque is high.

Input power is accepted through a single-phase supply, highlighted by the 1-phase specification, which simplifies wiring in facilities lacking three-phase feeders. A brake chopper is mounted Internal, so dynamic braking resistors can dissipate regenerated energy without external modules. The unit’s control fascia includes a knob that is supplied With potentiometer, letting technicians adjust output frequency locally during commissioning. Throughout its operating range the converter delivers the High overload capacity promised in the data sheet, yet its small panel classification and integrated fan guarantee thermal limits are respected without adding external cooling accessories.