Product Description:

The FECG01.2-19K0-3P400-A-BN-NNNN-01V01 is produced by Bosch Rexroth Indramat within the FEC Frequency Converters series. As a frequency converter, it changes the supply frequency so induction or synchronous motors can match the speed demands of general automation cells, conveyors, and material-handling lines. Installed between the power source and the motor, the unit gives a control cabinet electronic speed regulation without requiring mechanical gear changes. That lets upstream controls trim motor speed to suit load changes, transfer timing, and coordinated line movement. This supports smoother starts, controlled speed changes, and more consistent throughput across automated processes.

This model accepts a 3-phase mains connection and operates across an input range of 3 AC 380 to 480 V, while its nominal voltage class is 400 VAC. High short-term loading is supported through an overload ceiling of 200% for 1 second and a sustained margin of 150% for 60 seconds. These overload limits help the drive handle rapid acceleration or brief process jams without an immediate trip. The wide voltage range supports use in facilities where nominal line conditions vary by region or transformer arrangement. Because the device is supplied without a potentiometer, setpoint adjustments must be issued through the host controller or fieldbus interface rather than by a manual dial.

A protection rating of IP20 confines installation to ventilated enclosures while allowing direct access for wiring. The control electronics and power modules use a panel format described as Big size, which leaves more surface area for heat sinks and helps organize cable routing in larger cabinets. The converter is Design 2 and is a 1st generation product. Its open enclosure style is suited to cabinet installations where airflow paths and component spacing are managed at the panel level. It is intended for steady factory environments where enclosure ventilation and accessible cabinet mounting are available.