Product Description:

The DKS01.1-W030B-DL14-01-FW belongs to the DKS Intelligent Digital Servo Drives series manufactured by Bosch Rexroth Indramat. The drive receives command words, regulates motor current, and supervises feedback so automated axes maintain precise velocity and position in packaging, printing, or material-handling equipment. It is intended for servo applications that need closed-loop motion control with stable response during changing load conditions. The open-frame design is intended for mounting inside a control cabinet alongside other system electronics.

The power section accepts a three-phase supply of 3 x 230 V AC (±10%) or a single-phase feed at the same voltage level, and this input is rectified to an internal rail of 300 V DC. Under continuous load, the drive supplies a rated phase current of 30 A, and a pulse-width switching frequency of 18 kHz helps support smooth motor operation with reduced torque ripple. Operation is permitted at ambient temperatures up to +45 °C, and the IP10 enclosure is intended for protected cabinet installation rather than direct exposure. Cooling relies on passive heat dissipation with an internal bleeder resistor, while the input bridge accepts standard 50 Hz to 60 Hz mains. Above the rated temperature limit, output is reduced progressively until +55 °C.

During rapid deceleration, the internal bleeder resistor can dissipate bursts up to 5 kW, helping protect the power section from excess regenerated energy. The unit can be installed at elevations up to 1000 m above sea level without loss of capacity, and its reduced-noise classification supports use in enclosed control cabinets. Thermal losses are limited to 230 W at maximum electrical load, which helps when sizing cabinet ventilation. When the drive is not in operation, it can be stored from -30 °C to +85 °C for transport or warehousing.