Product Description:

Bosch Rexroth Indramat builds the DDS03.1-W050-DL01-00 for the DDS Drive Controllers series. The device is a digital AC servo drive controller intended to supply power and closed-loop regulation to synchronous or induction servomotors in automated production equipment. It processes reference values from higher-level controls, modulates output current to the motor windings, and feeds diagnostic data back to supervisory systems. This allows coordinated position, speed, and torque control in packaging machines, printing presses, and material-handling cells where stable axis response is required throughout repetitive production cycles.

During operation, the drive can continuously deliver a motor phase current of 50 A, allowing sustained output under normal loading conditions. Thermal energy is expelled through internal air cooling, so cabinet air moves across the heat sink instead of pulling contaminated air from the plant floor. For networked motion tasks, the controller uses single-axis position control, and it interprets rotor angle through digital servo feedback to maintain closed-loop accuracy during acceleration, deceleration, and steady-state running. The unit has IP20 protection, so it requires installation inside an enclosed control cabinet. Reliable drive response is maintained across an ambient range of 0 to 45 °C in typical climate-controlled equipment spaces.

The drive can be installed at elevations up to 1000 m above sea level without special cooling measures. Storage or transport can occur from -30 to 85 °C when the unit is not operating, which supports handling in warehouse and shipment conditions. The unit carries function identifier 01 in line 03 and version 1. Those identifiers indicate the assigned control behavior, monitoring settings, and fault response used by this model, helping keep operation consistent across matching units in the same product line.