Product Description:

The DDS02.2-W200-BE96-01-FW is a digital AC servo drive controller produced by Bosch Rexroth Indramat within the DDS Drive Controllers series. The unit coordinates torque, speed, and position commands between a compatible Indramat servo motor and higher-level automation through its fiber-optic communication link. It provides closed-loop motion regulation in one cabinet-mounted module, so separate external amplifier sections are not required. This arrangement supports precise axis control in automated equipment that depends on repeatable motor response during changing load conditions.

The drive communicates over the SERCOS interface, allowing deterministic command cycles and diagnostic messaging at the same time. A continuous output capability of 200 A supplies large synchronous or induction servomotors during acceleration and braking. Thermal energy is removed by internal air cooling, so cabinet air moves across the heat sink instead of relying on ambient shop airflow. For electrical safety, the device is protected to IP20, so it must be mounted inside a protected enclosure. The drive is intended for ambient temperatures from 0 to 45 °C, which keeps normal operation within the approved temperature range during full-load use.

The drive uses Function ID version 01, belongs to Line 02, and is Version 2. Installation is permitted up to 1000 m above sea level without derating, which covers most factory elevations. When powered down, the electronics tolerate storage temperatures from -30 to +85 °C. Feedback inputs accept both digital servo feedback and resolver signals, so the same controller can operate motors from different generations without interface adapters. This is useful in multi-axis machining centers, packaging lines, and material-handling cells where one control platform may need to support more than one motor feedback type.