Product Description:

The DDS02.1-W150-DS24-01 is a drive controller produced by Bosch Rexroth Indramat within the DDS Drive Controllers series. As a digital AC servo drive controller, it supplies controlled power to compatible motors so that industrial machinery can carry out precise speed, torque, and position commands. It is intended for servo systems that require synchronized axis control in packaging lines, handling equipment, and similar automated machinery. Integrated bus communication allows the unit to operate alongside other Rexroth modules in multi-axis racks. The controller manages motor current in real time so commanded motion remains responsive during acceleration and load changes.

Data exchange with higher-level control systems occurs over the SERCOS interface, which provides deterministic cyclic telegrams for real-time parameter updates and diagnostics. Fiber-optic communication supports reliable signal transfer in electrically noisy industrial environments. Continuous output is limited by a rated current of 150 A, which is the maximum armature current the drive can deliver without derating. Thermal energy released by switching devices is carried away through internal air cooling, so cabinet air moves past the heat sink instead of using an external blower. The housing is classified as IP20, which makes it finger-safe but suitable only for installation inside an enclosure. Closed-loop operation relies on digital servo feedback from the attached motor, enabling accurate commutation and quick correction of velocity errors.

Proper operation is specified between 0 to 45 °C, while non-operating storage is acceptable from -30 to 85 °C. Staying within these ranges helps protect insulation materials and electronic components during use and storage. Installation altitude may reach 1000 m without output reduction because the cooling method maintains adequate airflow at that height. The device belongs to Line 02 of the DDS family, which indicates its mechanical layout and connector position. This helps place the controller in the correct DDS system position without introducing unrelated module formats.