Product Description:

The DDS02.1-W015-DA01-00 belongs to the DDS Drive Controllers series produced by Bosch Rexroth Indramat. It is a digital AC servo drive controller designed to regulate torque, velocity, and position in synchronous or asynchronous servomotors used in multi-axis industrial automation cells. By converting command signals from a higher-level PLC into controlled three-phase output, the unit forms the central power and control stage between the machine controller and a feedback-equipped motor. This arrangement supports coordinated motion in handling systems, packaging lines, and automated assembly equipment.

The drive supplies up to 15 A of continuous output current, allowing it to operate medium-frame motors without overloading its power electronics during normal duty. Command data enter through the ANALOG interface, which allows straightforward integration with legacy motion cards that use voltage or current references instead of fieldbus communication. Rotor position is returned over digital servo feedback, so the controller can close its internal position loop with high resolution during every operating cycle. Heat generated by the IGBTs is removed by internal air cooling, so cabinet airflow must carry waste heat past the module's finned heat sink. The housing has an IP20 protection category, which helps prevent finger contact with live parts and requires installation inside an enclosed panel.

The device is rated for installations up to 1000 m above sea level, so it can be used in typical industrial locations without altitude-related derating. Reliable operation is supported in ambient temperatures from 0 to 45 °C, while non-operating storage or transport can occur from -30 to 85 °C without damaging the control boards. The unit carries Function ID 01 and is part of Line 02 with Version 1. These identifiers place the drive within a specific product configuration for compatible control and motor combinations.