Product Description:

The DDS02.1-F200-DA02-00 drive controller is manufactured by Bosch Rexroth Indramat within the DDS Drive Controllers series. As a digital AC servo drive controller, it converts command signals from higher-level motion processors into controlled three-phase power for servo motors used in pick-and-place stations, packaging axes, and machining centers. By handling current regulation, fault monitoring, and parameter storage inside a single rack-mounted module, the unit simplifies cabinet wiring and supports coordinated motion across multiple axes. Its layout also suits centralized control cabinets where several drives are installed side by side in the same enclosure.

The controller exchanges setpoints and feedback through an analog interface, permitting ±10 V speed or torque commands from legacy PLCs. Heat is removed by a coolant circuit that circulates through the baseplate, helping stabilize semiconductor temperatures during load changes. Installation is allowed up to 1000 m above sea level, and operation is rated for ambient temperatures from 0 to 45 °C. The electronics are protected by an IP20 enclosure, which helps prevent accidental contact and is intended for installation inside a closed control cabinet. This arrangement supports dependable operation in typical industrial environments without requiring direct exposure to the shop floor.

Continuous output capability reaches 200 A, giving the power section enough margin for high motor demand during acceleration and braking. When the unit is powered down, components tolerate storage temperatures from -30 to 85 °C, which supports transport and warehouse storage. Servo loop accuracy depends on the integrated digital servo feedback channel, which carries position data over a bidirectional encoder link so the controller can compare commanded and actual motion in real time. The drive is part of Line 02 and is released as Version 1. That revision information keeps the product identification clear within the series.