Product Description:

Bosch Rexroth Indramat builds the CSH01.3C-PL-NNN-NNN-CCD-L2-S-NN-FW as part of the CSH Advanced Controllers series. This unit is used in multi-axis drive systems where a dedicated controller coordinates motion, diagnostics, and machine safety. It occupies minimal panel depth, routes signals through standardized connectors, and provides the supervisory logic that links servo drives with upper-level PLCs in industrial automation. In operation, it serves as the control layer between the automation system and the connected drive hardware.

The module draws a basic power of 8.5 W, so cabinet power allocation remains modest, and a typical inrush current of 4 A must be considered when selecting circuit protection. Its housing depth is only 49.5 mm, allowing dense stacking beside other Rexroth control cards. The overall width is 103 mm, which helps keep the installation compact. Master communication is handled through a Parallel Interface, while cross-communication between IndraDrive controllers uses the CCD backplane bus. The front-mounted engineering port is an RJ-45, 8-Pin socket for configuration access and service communication. A standard single-line control panel gives direct access to operating states and fault codes.

Sixteen fast digital channels are provided as 16 Inputs, 16 Outputs, and output pulse widths can be gated down to 100 ms for time-critical machine sequences. The integrated safety circuit implements Safe Torque Off and uses a D-Sub 9-pin female safety connector. Two encoder slots are present but not equipped, so feedback adaptation is external to the board. The overall card height is 241 mm, which fits the compact vertical layout used by this controller. This arrangement allows the unit to handle control, signaling, and safety-related interfacing without requiring onboard encoder hardware.