Product Description:

The CSH01.2C-PB-NNN-MA1-CCD-NN-S-NN-FW is a controller card produced by Bosch Rexroth Indramat for the CSH Advanced Controllers series. It is intended to coordinate drive axes and peripheral devices in modular automation assemblies. In that role, it links motion control functions with local machine signals so command handling and response remain organized within one control layer. The card supplies motion commands, feedback handling, and field-level signal conditioning from one compact board, which suits machine layouts that combine axis control and nearby I/O on the same platform.

The module exchanges cyclic data with higher-level PLCs through the PROFIBUS-DP master interface, while deterministic peer traffic is handled over the IEEE 802.3 Ethernet cross-communication port. Local machine signals enter through 7 fixed digital inputs, and the unit provides 2 built-in analog outputs for external control signals. An additional bank of four configurable digital I/O lines supports flexible routing, and each output channel may source up to 500 mA with a combined group limit of 1000 mA. Two probe inputs support fast position latching for registration tasks where signal timing must be captured precisely. The MA1 expansion adds two input and two output channels with 12 bit resolution over a ±10 V span for fine analog feedback or set-point handling.

Service connectivity is supplied by an RS232 port that transmits up to 115 kBaud across cable runs of 15 m, allowing direct serial parameter access when a local connection is preferred. Discrete power stages or indicator lamps can be driven by the relay output rated at 30 VDC, 1 A. A Single-line display shows status codes directly on the unit, so basic operating information remains available without relying on network access. This layout keeps diagnostics straightforward while leaving the main communication channels available for control traffic.