Product Description:

The CSH01.1C-PB-EN2-EN2-MA1-NN-S-NN-FW control section belongs to the CSH Advanced Controllers series manufactured by Bosch Rexroth Indramat. It is a plug-in motion and I/O processor that mounts on an IndraDrive power base to manage axis commands, feedback processing, and fieldbus traffic inside automated equipment. By combining encoder evaluation, local signal conditioning, and network mastering on one compact board, the unit supports coordinated positioning, speed regulation, and machine sequence control in packaging lines, material-handling gantries, and similar industrial systems.

The card draws only 7.5 W from the 24 V logic rail, so it generates little heat and places a small load on cabinet power supplies. Its digital interface bank provides 11 In / 4 Out, allowing direct connection of limit switches, sensor flags, and status lamps without extra modules. For process variables that require proportional signaling, the built-in analog section offers 1 In / 2 Out channels for velocity, torque, or pressure references. Its overall size of 241 x 103 x 49.5 mm helps the control section fit beside other IndraDrive components in compact cabinet layouts. As the master interface, the onboard PROFIBUS-DP port handles cyclic command and diagnostic data exchange with PLCs or cell controllers, permitting synchronized multi-axis operation over a widely used fieldbus.

A shielded network lead plugs into a D-Sub 9 Female connector, and the repeater circuit can refresh the bus while consuming 75 mA of segment current. For local service tasks, an RS-232 port supports parameter transfer or trace capture at up to 115 kbaud through a 15 m cable. Encoder feedback from linear or rotary scales may be routed over EnDat wiring that can extend to 75 m when sense conductors are used. The interface supplies up to 350 mA to power the transducers during operation.