Product Description

The CSH01.3C-PB-EN2-NNN-CCD-S2-S-NN-FW advanced control section uses a multimedia card to read and store different types of data such as drive parameters, firmware and operating data. The Bosch Rexroth section has a Normally Open factory setting for the Type 2 relay contact. This product incorporates one protective diode in its power supply at the X31.8 connector for protection against incorrect connection. The device must be used with signal sources that have the least impedance at its analog input for a low degree of linearity error. This unit houses probe inputs that are rapid and should be controlled using electronic switches so that incorrect evaluation can be avoided.

The section has one analog input and two analog outputs. Its EnDat 2.1 / 1 Vpp / TTL encoder supports a supply voltage of 5V +/-5%. The product is connected with its cross-communication module featuring two yellow LEDs and two green LEDs at the X24 and X25 connecting points. This device is meant to be connected with the cross-communication module using either a short RKB0013 cable or a long RKB0011 cable from the manufacturer. The unit comprises several connectors that cannot be plugged in or removed when it has been powered on. Its cross-communication module features Ethernet standards with 100Base-TX compatibility according to IEEE 802.3u standards. This control section portrays a warranty duration of one year.

The product must have the standard control panel already plugged in when the associated drive controller is turned on for it to be recognized. This device helps the user to set the analog inputs with its control panel. The unit-associated relay contact has a current carrying capacity of 1ADC and a voltage load capacity of 30VDC. Its relay contact also has an ohmic time constant of load. This section features a surface temperature of over 60°C during use. This control section shipment takes place anywhere across the globe.