Product Description:

The BTV30.1CA-08R-50B-D-010200-FW is an operator interface engineered by Bosch Rexroth Indramat for the BTV30 Machine Control Terminals series. As a machine control terminal, it links CNC axes, drives, and peripheral I/O so an operator can issue motion commands and monitor process data in one enclosure. Its purpose in an automated cell is to combine visualization, key-controlled functions, and data storage so production parameters can be adjusted at the machine without opening the control cabinet. This layout keeps routine interaction at the terminal instead of at separate cabinet hardware.

A 10.4-inch TFT panel provides a viewing area that reproduces graphics and text at 640 × 480 px, and this resolution matches the US key legends so G-code messages appear clearly without scaling. The diagonal size of 10.4 in keeps the overall dimensions to 407 × 370 × 220 mm, letting the unit fit into shallow pendant housings. A Pentium 166 MHz processor runs the terminal software, while the minimum 500 MB hard drive and 3.5-inch, 1.44 MB disk drive store part programs and parameter backups. The autoranging power section accepts 115/230 VAC mains so the same terminal can be wired in North American or European panels; at full load it draws up to 250 VA, which helps when sizing upstream power equipment.

Protection and durability details supplement the electrical data. The front bezel carries an IP65 seal, stopping coolant splash and airborne chips, while the rear housing remains suited to protected cabinet-side installation and natural convection. During transport or accidental impact the electronics survive shocks up to 175 g for 2 ms, and continuous vibration resistance is aided by a total mass of 10.5 kg. Internally the switched-mode supply tolerates line frequencies from 47–63 Hz, so the terminal can operate on either 50 Hz or 60 Hz systems without a separate variant.