RC28-14/30 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R917007683
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat RC28-14/30 is part of the BODAS Controllers series. It features a nominal supply voltage of 12 V or 24 V and uses twisted pair CAN/ISOBUS cable type. The controller is mounted using metal screws, has a maximum tightening torque of 10.0 Nm, and a recommended screw size of M6.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The RC28-14/30 belongs to the BODAS Controllers series from Bosch Rexroth Indramat. As an electronic control unit, it supervises valves, pumps, and sensor networks in mobile or stationary hydraulic equipment, coordinating machine functions by interpreting input signals and issuing deterministic outputs. This role lets the module run user-defined software for proportional actuation, safety interlocks, and diagnostic routines. It can serve as the central control layer in hydraulic systems that need repeatable signal processing during changing operating conditions.
For data exchange on vehicle or plant buses, the controller connects through a CAN/ISOBUS harness that must use twisted-pair conductors to limit electromagnetic emissions. Mechanical retention relies on metal screws, and the wiring loom should be supported by clips or ties spaced at less than 150 mm to reduce cable movement in high-vibration areas. When the housing is clamped, the screws may be tightened to a maximum of 10.0 Nm; staying within that limit helps protect the threads and preserve the enclosure seal. The device should also maintain at least 1 mm of clearance from neighboring components so that heat can dissipate and adjacent surfaces do not interfere with installation. Careful cable routing also helps maintain stable communication and reduces stress at the connector entry points.
Mounting precision affects the thermal path, so the contact surface should be flat within 0.5 mm to keep the aluminum backplate in full contact for conduction cooling. Internally, the logic and power stages can operate from either 12 V or 24 V, allowing the same controller platform to be used in different machine electrical systems. Each unit is secured with M6 fasteners, which supports consistent installation on common brackets and panels. Good surface contact improves heat transfer during continuous operation, and a flat mounting surface also reduces localized mechanical stress across the housing. These mounting conditions help the controller remain stable where vibration and thermal cycling are part of normal service.
Frequently Asked Questions about RC28-14/30:
Q: What type of CAN/ISOBUS cable is required for the RC28-14/30 controller?
A: The RC28-14/30 BODAS Controller uses a twisted pair cable for CAN/ISOBUS connections.
Q: What screw size should be used to mount the RC28-14/30 controller?
A: The recommended screw size for mounting the RC28-14/30 is M6.
Q: What supply voltages does the RC28-14/30 controller support?
A: The RC28-14/30 controller supports a nominal supply voltage of 12 V or 24 V.
Q: What is the maximum tightening torque allowed for the RC28-14/30 controller's fasteners?
A: The maximum tightening torque for mounting the RC28-14/30 is 10.0 Nm.
Q: What is the minimum mounting clearance specified for the RC28-14/30 controller?
A: A minimum mounting clearance of 1 mm is required around the RC28-14/30 controller.
