RC10-10/31 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R917010287
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat RC10-10/31 is a controller from the BODAS Controllers series with 10 proportional outputs and 10 switched outputs. It features a supply voltage of 12 or 24 volts and a maximum tightening torque of 10.0 Newton-meters. The controller supports a recommended screw size of M6 and requires a minimum mounting gap of 1 millimeter.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The RC10-10/31 is an electronic controller produced by Bosch Rexroth Indramat for the BODAS Controllers series. It functions as a programmable unit that routes current to multiple actuators, allowing coordinated proportional and on/off control loops inside industrial automation assemblies. By combining logic processing with ruggedized I/O terminals, the device simplifies wiring between sensors, valves, and supervisory equipment in mobile machinery and stationary control systems. Its role is to receive input signals, process programmed logic, and send controlled output signals to connected field devices.
This controller operates from a dual-rated supply of 12/24 V, letting it interface with common automotive or plant power buses without additional converters. It provides 10 proportional outputs for valve control through pulse-width or current regulation, and it also includes 10 switched outputs for direct binary activation of lamps, relays, or solenoids. This mix of output types allows one housing to manage continuously variable functions and simple switching tasks at the same time. Mechanical attachment uses fasteners tightened to a maximum of 10.0 Nm, and the mounting points are sized for M6 screws. Harness strain relief must be added at intervals not exceeding 150 mm to reduce vibration loads on the connector block. During storage, relative humidity should remain below the condensation range so the electronics and connector surfaces stay dry.
Installation requires a minimum clearance of 1 mm around the enclosure to avoid mechanical interference with adjacent parts. That spacing helps prevent contact with nearby brackets, panels, or cable hardware after the unit is mounted. The mounting plate may deviate by no more than 0.5 mm across the contact area so the housing and internal boards are not stressed during fastening. Flat mounting also supports secure connector alignment over time. Stored units should be checked at least every 5 years to confirm that the controller remains ready for service after extended shelf time. Periodic checks after long storage can reveal aging before the controller is returned to operation.
Frequently Asked Questions about RC10-10/31:
Q: What supply voltage does the RC10-10/31 controller require?
A: The RC10-10/31 BODAS Controller operates with a supply voltage of 12 or 24 volts.
Q: How many proportional outputs are included on the RC10-10/31 controller?
A: This model features 10 proportional outputs, allowing control of multiple devices at variable levels.
Q: What screw size is recommended for mounting the RC10-10/31 controller?
A: A recommended screw size of M6 is specified for mounting the RC10-10/31.
Q: What is the maximum allowed harness support spacing for the RC10-10/31?
A: The RC10-10/31 allows a maximum harness support spacing of up to 150 mm.
Q: How often should storage checks be performed on the RC10-10/31 controller?
A: It is recommended to perform a storage check on the RC10-10/31 every 5 years.
