Product Description:

The ADP164C-B35OB1-BS2H-B2V1 belongs to the ADP 3-Phase Induction Motors series manufactured by Bosch Rexroth Indramat. As a three-phase rotating machine, it converts AC power into mechanical motion for conveyors, packaging axes, and other duty-cycle equipment in automated lines. Closed-loop operation with Rexroth inverters allows precise speed and torque control without external contactors, and the top-entry terminals specified by connection code B simplify routing inside control cabinets. This arrangement supports repeatable motor response during speed changes and load variations in automated handling systems.

To handle axial and radial loads, the motor is built with reinforced bearings, and the upgraded bearing seats tolerate higher belt pull and shock. Motion can be held at rest by an electromagnetic 24 Nm brake, which engages when power is removed to secure vertical axes. A dedicated blower runs from a 230 V cooling supply, so the stator temperature stays within limits at low shaft speeds. Installation flexibility is provided by flange or foot mounting, allowing alignment with either IEC flanges or base plates. Position and speed data are returned through Heidenhain servo feedback, enabling high-resolution control loops with minimal following error. The terminals face upward because the power connection is on the top, and direction code B helps keep cable bends minimal while maintaining clearance.

The stator diameter coded as motor size 164 establishes the frame outline and sets the thermal surface area available for heat exchange. Axial envelope is expressed by motor length C, giving a specific stack length for machine layout planning. Torque is transmitted through a whole parallel-key shaft, which helps prevent slippage during repeated start-stop cycles. The housing is supplied with no shaft seal, so fluid exclusion must be handled externally where required. The motor meets vibration severity level R, indicating suitability for high-speed duty without additional balancing hardware.