Product Description:

The ADP164C-B35OB1-BS0H-D2N1 is a three-phase induction motor produced by Bosch Rexroth Indramat within the ADP 3-Phase Induction Motors series. It converts electrical energy from a fixed-frequency mains supply into rotational motion that can drive conveyors, pumps, or position-controlled axes when paired with an inverter. In distributed automation layouts, the motor serves as the mechanical work unit while rotor feedback allows the drive controller to close a speed or torque loop and keep motion synchronized with the overall process.

This model dissipates stator heat through an external blower that runs on 230 V, helping keep winding temperature within the thermal range during continuous duty. The motor has no brake installed, so the shaft can coast to rest and any holding torque must come from the drive or an external brake. The motor uses Heidenhain servo feedback, and this high-resolution interface supplies position data to the inverter for accurate vector control. The motor has size code 164 and length code C, giving a mid-length rotor that balances torque density against overall weight. The housing supports flange or foot mounting, allowing either rigid base plates or end-bell flanges to be used. Electrical entry follows power-cable direction B, so conductors exit on the drive-end side and can be routed inside compact panels without tight bends.

The output shaft uses a whole parallel key to transfer torque and eliminate slip at the hub interface, and a shaft seal helps limit lubricant migration while reducing dust ingress. Power terminals are located on the top of the stator housing, which simplifies downward cable drops from overhead cable trays. Internally, standard bearings support the rotor and are matched to vibration severity R, which is appropriate for general-purpose plant equipment operated on compliant isolation pads.