Product Description:

The ADP164C-B35OB1-BS0H-A2N1 is a three-phase induction motor produced by Bosch Rexroth Indramat for the ADP 3-Phase Induction Motors series. It converts electrical power into continuous rotary motion for conveyors, pumps, and positioning axes that do not require permanent-magnet excitation. When paired with Rexroth inverters, the unit supplies slip-controlled torque for automation lines that need dependable rotation under encoder supervision.

Internally, the rotor runs on standard bearings, providing balanced load capacity and service life for general-purpose duty cycles. External cooling is driven by a blower fed from 230 V, so heat removal is independent of motor speed. Machine builders can align the housing with frames by using flange or foot mounting interfaces, which support both face and base installation patterns. Closed-loop positioning is supported because the motor carries servo feedback (Heidenhain), and this encoder sends speed and angle data to the drive for precise slip compensation. The designation motor length C indicates the active lamination stack, which affects torque density and overall mass. A brake is not installed, so stopping torque must come from the drive or external mechanics. Power cables enter on the top of the housing, and direction code B orients the glands toward the drive cabinet.

The frame designation motor size 164 sets the mounting pitch and shaft height, helping the motor fit common IEC mid-power housings. A smooth shaft is supplied, so the user must select clamp or shrink couplings instead of keyways. Because the motor has no shaft seal, it should avoid exposure to oil spray or coolant, or an external seal must be added. Dynamic balance follows vibration severity level R, which helps limit displacement and bearing stress during startup and steady operation.