Product Description:

The ADP134D-B05OB2-CS0H-A2N2 is an AC induction motor produced by Bosch Rexroth Indramat for the ADP 3-Phase Induction Motors series. Within an automation cell, it converts electrical power into mechanical rotation for conveyors, indexing tables, and similar duty cycles controlled by frequency inverters. Its three-phase induction design supports operation with standard mains supplies and compatible drive modules, while the magnetic circuit is intended for smooth continuous running.

The motor uses a flange-mounted interface, allowing the stator housing to bolt directly to gear units or machine plates without foot adapters, which shortens the powertrain length and improves alignment. Its external blower operates from a dedicated 230 V supply so that cooling airflow remains stable during low-speed operation commanded by the drive. Motion control relies on Heidenhain servo feedback; the encoder transmits absolute rotor position, enabling closed-loop torque regulation and rapid acceleration profiles. Frame sizing follows Bosch Rexroth conventions, and the designation motor size 134 corresponds to large-diameter stator laminations that increase thermal mass and torque density. A smooth shaft supports backlash-free clamping couplings instead of keyed transmission elements.

The rotating assembly is supported by standard bearings suited for general radial and axial loads. With no brake installed, the application must rely on the inverter for stopping or holding torque. Power enters from the top through the terminal at the top power connection location, and together with connection direction code B this arrangement simplifies vertical cable runs. Because there is no shaft seal, the motor should not be exposed to fluid spray unless an external seal is added. The motor also has length D, vibration severity level S for balanced operation, and winding code CS matched to the electrical characteristics of the ADP drive family.