Product Description:

The ADP134C-B35OB2-DS0H-B2N1 is an induction motor produced by Bosch Rexroth Indramat for the ADP 3-Phase Induction Motors series. Designed for continuous duty in industrial automation, the unit converts regulated three-phase power from a drive into controlled torque and speed for conveyors, presses, or machining axes. In variable-speed systems, this arrangement lets the controller adjust motor output to match process demand while maintaining stable motion. Its frame follows the series footprint, so it fits machine layouts built for this motor platform. The motor is suited to automated stations that require repeatable acceleration and steady operation over long run times.

This motor draws cooling-fan power from 230 V, so the blower runs directly from the control supply. The stator diameter corresponds to motor size 134, and the core length is motor length C, placing the unit in a medium-torque range within the family. Shaft torque is transmitted by a whole parallel key, which provides a positive interface with couplings and driven elements. The rotor rides on standard bearings, and power cables enter through the top gland before exiting toward side B for straightforward routing. The housing supports flange or foot mounting for horizontal base or face installation without adapters.

The encoder interface uses servo feedback (Heidenhain) to deliver high-resolution position data for closed-loop regulation. This feedback arrangement helps the drive monitor rotor position and speed during regulated operation. The motor has no shaft seal, so it should be installed in clean, dry areas or equipped with an external seal where spray is present. It is rated for vibration severity level R, which supports operation under elevated dynamic loads. Electrical behavior follows winding code DS, so the matched drive must provide the corresponding current profile. No brake is installed, so holding torque must come from the load or from drive-produced static current.