Product Description:

The ADP134B-B35OB1-FS0H-B2N1 is an AC induction motor produced by Bosch Rexroth Indramat for the ADP 3-Phase Induction Motors series. The unit supplies continuous torque for automated conveyors, presses, and processing equipment where reliable speed regulation is required. In an automation cell, it acts as the prime mover that converts inverter output into mechanical rotation at the driven shaft. It is intended for inverter-fed systems that need steady torque during repeated production cycles.

To meet general-purpose machine duty, the motor is assembled with standard bearings, providing predictable service life under radial and axial loads typical of industrial couplings. Because there is no brake installed, stopping and holding must be managed by the external drive or by mechanical clamping devices. The internal blower operates on 230 V, so a separate low-voltage supply is unnecessary. The frame supports flange or foot mounting, allowing vertical or horizontal installation without extra brackets. Closed-loop motion is enabled by Heidenhain servo feedback, which sends high-resolution position data to the controller. This arrangement supports speed-regulated applications that also need accurate rotor position data. The FS winding code sets the motor's thermal behavior, magnetic characteristics, and resistance values for use with compatible drive parameters.

The motor has size 134 with length variant B, giving shaft height and stack depth suitable for medium-frame gearboxes. Torque is transmitted through a whole parallel key on the output shaft, which helps the coupling resist torsional shock. The housing is supplied with no shaft seal, so it should be installed where oil splash and high humidity are controlled. That arrangement is better suited to cleaner installation areas than to locations with frequent fluid exposure. Power enters from the top of the stator, and the connectors face the rear because the direction identifier is B, which helps reduce cable bend during vertical mounting. Dynamic balance meets vibration severity level R, permitting operation on rigid bases without added damping hardware.