Product Description:

The 2AD200C-B35RA1-AS03-D2N1 is an AC induction motor produced by Bosch Rexroth Indramat within the 2AD 3-Phase Induction Motors series. Designed for integration with inverter-based controls, it converts electrical energy into continuous rotary motion for conveyors, presses, and machining axes. In typical service, it is used where steady torque and accurate speed regulation are needed over long operating periods. The motor’s sealed housing, keyed shaft, and forced-air cooling support long production runs in industrial automation cells where uptime and positional repeatability are important.

Cooling air is forced through the stator by an axial blower, which keeps winding temperature within limits during extended duty. With a frame size of 200 and a motor length code of C, the motor balances power density and installation depth for cabinet or base mounting. The unit is supplied without a holding brake, so stopping torque must be furnished by the drive or external mechanics. Shaft position is read through high-resolution motor feedback, allowing the controller to process angle increments for precise vector control. This feedback arrangement supports stable speed control across a wide operating range. Standard rolling bearings support the radial and axial loads expected in general-purpose drives.

Electrical power reaches the stator through a junction box mounted on the right side when viewed toward the shaft, and conductors exit on Side A to simplify cable routing along machine frames. Flange and foot mounting holes allow the housing to be fastened to vertical plates or base rails without adapters. Dynamic balance is supported by a sealed shaft with the key installed across its full length, while the opposite end is delivered without a shaft extension for close-coupled loads. The rotor meets vibration grade R, and the stator uses winding code AS to match drive parameters for thermal class and impedance.