Product Description:

The 2AD200C-B35OB6-AS03-B2N1 belongs to the 2AD three-phase induction motors series from Bosch Rexroth Indramat. This motor is intended for automation axes that need continuous rotary power, such as machine-tool spindles or conveyor drives in automated equipment. It converts three-phase electrical energy into mechanical torque and works with drive controllers that rely on feedback to maintain speed, load regulation, and stable response during demanding industrial duty cycles.

Its active thermal management uses a radial blower mounted on the housing to push cooling air along the stator ducts, allowing the size 200 frame to dissipate losses without external ducts. Installation flexibility is provided by flange and foot mounting, so the motor can be secured to a baseplate or bolted directly to a gearbox. Power conductors enter through a junction box located on the top of the motor, which helps keep cable routing direct in tightly packed layouts. Torque and position loops are closed with high-resolution motor feedback, which supplies the drive with precise rotor angle information during acceleration. Standard bearings support the C-length rotor, and the motor is supplied without a holding brake to reduce inertia when fast stops are handled electrically. The B-side has no shaft end, which keeps the blower clear of mechanical loads.

The power entry is on side B, so cable strain relief aligns with the blower, while the internal conductors use winding code AS to match drive voltage and current requirements. The motor uses Vibration Grade R, so the mounting surface should keep transmitted forces within that tolerance during operation. The shaft runs without a shaft seal, which suits environments where oil mist exclusion is not required, and it is balanced with the entire key installed. It is an AC induction motor, so torque is produced by induced rotor currents rather than permanent magnets.