Product Description:

The 2AD200C-B35OB1-AS06-H2N2 is an AC induction motor manufactured by Bosch Rexroth Indramat for the 2AD 3-Phase Induction Motors series. The unit serves as a prime mover for conveyors, printing presses, and other continuous-duty axes where constant torque and speed regulation are required. Its length code C and size code 200 indicate the active stack height and frame dimensions while remaining compatible with standard B35 combination mounting on machinery frames.

This motor is cooled by an axial blower, which pushes air along the housing to remove heat from the AS winding set. Position and speed are monitored through digital servo feedback, allowing the drive to close fine control loops without external encoders. Mechanical installation uses flange and foot mounting, so the frame can be secured at the end shield or on an integral base. Power conductors enter from the top and are routed to side B, which helps avoid sharp cable bends and leaves service space on the opposite face. Side B carries no shaft, so couplings are limited to the driven end and overhang loads are reduced.

Electrical leads terminate inside a sealed junction box, which provides strain relief and allows field wiring changes without disturbing internal connections. Rotary transmission is delivered through a shaft that is with a shaft seal and balanced with a half key, which helps limit oil leakage and keeps the rotor properly balanced when the mating half key is installed. The bearing arrangement is standard and satisfies the vibration limits of grade S. The motor is supplied without a holding brake, which lightens the rotor and shortens coast-down time for inverter-controlled deceleration where the drive provides dynamic stopping torque. The AS winding code aligns the electrical characteristics with regulated three-phase supplies.