2AD200C-B35LB2-AS06-A2V1

Product Description:

The 2AD200C-B35LB2-AS06-A2V1 lands straight in Bosch Rexroth Indramat’s 2AD 3-Phase Induction Motors group and shows up with a good balance between muscle and size. Frame size clocks at 200 mm, so the housing isn’t hard to fit even into cramped automation stations. With a rated power of 6.0 kW, it’s more than capable for assembly, conveyor lines, and even smaller machining stations, while not pushing things too far on the install. Rated speed hits 3000 rpm, and that means it works for spots where a steady, predictable motion matters most. Rated torque is 19.1 Nm to help pick up start/stop routines clean without a shudder.

Cooling comes through a direct axial fan (A2V1), and with this setup, the air keeps flowing across the frame, making sure run times don’t overheat anything. The IP65 protection class holds its own against dust and spray, though there’s an exception at the shaft end — a note to check before placing somewhere with a big dust problem. Top cable access and side connectors (catalog AS06) allow fitting into tight panels where space runs short. At about 42 kg weight, installs need one strong worker or a hoist, but nothing extreme for most mid-size automation frames.

Feedback’s covered by an incremental encoder, built in, which speaks up for position control during precise moves; pretty useful for repeat jobs. The 400V class voltage rating marks it as fit for modern plants using standard drives and cabinets. Mounting is done with a B35 flange configuration, meaning plant modifications aren’t needed since it lines up with common placements right out of the box. The finish on this servo motor feels reliable, and the combo of fan cooling, protected wiring, and live encoder signal helps take up most roles on automated lines where clean movement, low noise, and easy monitoring count for more than raw horsepower.