Product Description:

The 2AD184C-B35OE1-CS06-B2V1 is an AC induction motor produced by Bosch Rexroth Indramat within the 2AD 3-Phase Induction Motors series. This frame 184 machine provides rotary power for automation axes that require continuous torque and straightforward speed control through a matched inverter. In plant equipment, it converts three-phase electrical energy into mechanical rotation so conveyors, spindles, or auxiliary drives can run at commanded speeds. When paired with a suitable inverter, the motor can support steady-running process sections as well as coordinated machine movements that require repeatable speed behavior.

Thermal management is handled by an axial blower that moves cooling air through the stator stack, and the blower is rated at 400 V so it can be supplied directly from common auxiliary circuits. Encoder data reaches the drive via digital servo feedback, allowing closed-loop regulation of speed and slip during operation. Operational reliability is supported by heavy-duty bearings that tolerate elevated radial loads during continuous duty. The frame identifier 184 sets the stator diameter and the mechanical interface dimensions used across the series. The housing supports flange and foot mounting, allowing either face mounting or base mounting depending on the machine layout.

The length code C corresponds to the active core depth used on this model. Vibration behavior follows grade R, so balancing quality is suitable for medium-speed industrial shafts without additional damping hardware. The stator windings use code CS, which matches the electrical characteristics expected by compatible Bosch Rexroth inverters. No holding brake is fitted, so position retention must be provided by external mechanisms when power is off. Power cables enter a junction box on the top of the frame, and the conduit faces right to keep routing clear of floor mounts. The drive end carries a keyed shaft that is balanced with the full key inserted, while the opposite side is supplied without a second shaft extension or shaft seal, reducing length and limiting possible ingress points.