Product Description:

The 2AD184C-B35OC1-CS07-A2N1 is an AC induction motor produced by Bosch Rexroth Indramat within the 2AD 3-Phase Induction Motors series. In automated machining centers, packaging lines, continuous process equipment, and material-handling cells, the unit converts electrical energy into rotational torque for pumps, conveyors, and spindle drives. Its design supports closed-loop control with a compatible drive controller and suits long-duty industrial operation where stable speed and torque are required. This motor type is also well suited to applications that demand steady rotation under changing load conditions.

Thermal management uses an integrated axial blower that pushes air through the stator channels. This active cooling helps the motor maintain rated output during cyclic overloads. The blower runs from a 400 V auxiliary supply, so no step-down transformer is required. Mechanical installation flexibility comes from flange and foot mounting, letting the frame bolt to a baseplate or directly to a gearbox housing. Power enters through a junction box on the top of the frame, and the terminals face Side A for straightforward conduit routing. Standard bearings support the rotor, and vibration grade R limits are applied at the factory.

Precise motion control is enabled by digital feedback with a multi-turn absolute encoder, providing position data across the full travel without a homing move after power loss. Frame size code 184 with length code C provides the iron stack used for the CS winding. The drive end carries a smooth shaft without a shaft seal, and the B-side has no shaft extension, simplifying alignment. Dynamic behavior stays within the R vibration grade, assisted by standard deep-groove bearings. The motor is supplied without a holding brake, so standstill holding must come from drive torque or an external clamp. Power and feedback connections are arranged to help keep encoder and blower cables separated from the mains conductors.