Product Description:

The 2AD184C-B35OC1-CS06-B2N1 is an AC induction motor produced by Bosch Rexroth Indramat as part of the 2AD 3-Phase Induction Motors series. It is intended for continuous operation in automated presses, gantries, and material-handling stations where reliable three-phase torque is required. By integrating with frequency inverters on the plant network, the motor converts electrical input to controlled mechanical rotation, supporting coordinated motion sequences in industrial automation cells. Its operating role suits applications that need stable speed control during repeated starts, stops, and load changes.

Cooling is provided by an axial blower mounted on the housing, and the impeller is energized from a dedicated 400 V supply so airflow is maintained even when the shaft is stationary. Position data is returned to the controller through digital servo feedback, allowing the inverter to correct slip and maintain commanded speed. The motor has size 184, which corresponds to its stator diameter, while length code C extends the active lamination stack for higher thermal capacity. Winding code CS indicates the coil pitch and insulation system matched to standard 50/60 Hz mains. Standard bearings support combined loads, and the unit is supplied without a holding brake to avoid residual drag during rapid cycling.

Mechanical integration is simplified by flange and foot mounting, enabling the frame to bolt either to a machine base or to a C-face bracket. Power conductors enter through a junction box fixed on the top of the enclosure and oriented toward side A, which eases routing in vertical installations. Vibration grade R limits peak displacement so coupled gear sets remain within alignment tolerances during operation. The shaft is balanced with the complete key and has no shaft seal, while the opposite end of the rotor is left blank to avoid interference with rear-side components. Bearings are lifetime lubricated, which reduces routine service requirements in enclosed machine layouts.