Product Description:

The 2AD180D-B35OA1-BS06-B2N1 is an AC induction motor produced by Bosch Rexroth Indramat for the 2AD 3-Phase Induction Motors series. The model belongs to the manufacturer's high-inertia drive line and supports coordinated axes in material-handling cells. Its rotor characteristics help smooth speed changes in applications with substantial rotating masses. This type of motor is commonly used in equipment that runs for long periods under stable load. As an induction machine, it delivers continuous torque from three-phase power and serves as a drive element for pumps, extruders, and other industrial actuators that require sustained output.

Thermal management is handled by an axial blower that drives cooling air along the housing to remove heat losses. Position feedback comes from digital servo feedback, enabling the drive controller to close velocity and vector current loops without external encoders. The motor uses frame size 180, which corresponds to a stator outer diameter near 180 mm. For installation flexibility, it supports flange and foot mounting, so it can be fastened to a base plate or directly to a machine wall. Power conductors terminate in a terminal box, providing a separate cavity for line and ground wiring. Standard bearings carry radial and axial loads and are prelubricated for service life.

The motor has length code D, which indicates an extended active core stack for higher continuous power at the same frame diameter. Incoming cables enter from the top of the enclosure and are routed toward Side A, which can simplify cable routing when the motor is mounted close to gearboxes or couplings on that end. The motor uses vibration grade R, so the rotor meets precision balance requirements without additional trim weights. Its electromagnetic characteristics match winding code BS, which pairs the stator with compatible 2AD drives for correct current and slip behavior. The motor is supplied without a holding brake, has no shaft end on side B, and uses a keyed shaft without a seal for dry operating areas where a shaft seal is not required.