Product Description:

Bosch Rexroth Indramat manufactures the 2AD180C-B35RR1-BS03-D2N1, a member of the 2AD 3-Phase Induction Motors series used to drive pumps, compressors, and material-handling equipment in automated lines. The part uses a stator and compact rotor package that provide high continuous torque from a footprint that still fits B35 combination flange and foot frames. In factory cells, this motor converts electrical input into mechanical rotation for conveyors or gearboxes that must run for long shifts with minimal maintenance.

An axial blower forces cooling air over the housing so temperature rise stays within insulation limits during continuous duty. Mounting flexibility comes from flange and foot mounting, which lets the same model bolt to a machine wall or rest on a skid. Power conductors enter through a terminal box placed on the right side when looking toward the output shaft, and that position simplifies parallel routing of power and feedback cables. Motion data is returned by high-resolution motor feedback, enabling closed-loop drives to command tight speed or position tolerances. Standard-grade bearings support radial and axial loads typically encountered in belt-driven or direct-coupled systems, and the C length code indicates the active stack height for this motor.

The motor is an AC induction motor, so torque is produced by stator-generated rotating fields rather than permanent magnets. It is supplied without a holding brake, leaving dynamic stopping to the inverter or an external mechanical lock. The output shaft includes a balanced key with a shaft seal to help reduce leakage and preserve balance at high speed, and the rear face is machined without a shaft end to simplify mounting close to bulkheads. A R vibration grade supports installation on frames subject to moderate dynamic loads, the 180 frame size provides ample thermal mass for constant-torque duty, and winding designation BS identifies the winding version used for this motor.